Alcatel-Lucent 6850-48 参照ガイド

IP Commands

page 32-32

OmniSwitch CLI Reference Guide

Matches the route with the specified IPv6 address or an address defined in the specified IPv6 access list.

ip route-map route-map-name [sequence-number number] match ipv6-address {access-list-name | 
ipv6_address/prefixLen [redist-control {all-subnets | no-subnets | aggregate}] [permit | deny]

no ip route-map route-map-name [sequence-number number] match ipv6-address ipv6_address/prefix-
Len [redist-control {all-subnets | no-subnets | aggregate}] [permit | deny]

The name of the route map (up to 20 characters).

A number that links together the route maps. The range is 1–100.

The name of an IPv4 access list that contains IPv4 addresses to match.

The destination IPv6 address along with the prefix length of the routes 
to be redistributed.

Redistributes all the subnet routes that match the network portion of the 
IP address as specified by the mask length.

Redistributes only those routes that exactly match the IP address and the 
mask length.

Redistributes an aggregate route if there are one or more routes that 
match the IPv6 address.

Permits a route based on the IPv6 address or prefix constrained by 
redist-control.

Denies a route based on the IPv6 address or prefix constrained by redist-
control.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to delete the match ipv6-address redist-control parameter in the 

route map.

• Specify either the name of an existing IPv6 access list or an IPv6 address/prefix length with this 

command. 

50