Alcatel-Lucent 6850-48 参照ガイド
IP Commands
page 32-104
OmniSwitch CLI Reference Guide
September 2009
show ip redist
Displays the IPv4 route map redistribution configuration.
show ip redist [rip | ospf | bgp]
Syntax Definitions
rip
Displays route map redistribution configurations that use RIP as the
destination (into) protocol.
destination (into) protocol.
ospf
Displays route map redistribution configurations that specify OSPF as
the destination (into) protocol.
the destination (into) protocol.
bgp
Displays the route map redistribution configurations that specify BGP as
the destination (into) protocol at this time.
the destination (into) protocol at this time.
Defaults
By default all route map redistribution configurations are shown.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
Specify a destination protocol with this command to display only those configurations that redistribute
routes into the specified protocol.
routes into the specified protocol.
Release History
Release 6.1.3; command was introduced.
Examples
-> show ip redist
Source Destination
Protocol Protocol Status Route Map
------------+------------+---------+--------------------
RIP OSPF Enabled ipv4rm
BGP RIP Enabled ipv4rm
-> show ip redist rip
Source Destination
Protocol Protocol Status Route Map
------------+------------+---------+--------------------
BGP RIP Enabled ipv4rm