Alcatel-Lucent 6850-48 参照ガイド

IPv6 Commands

page 33-6

OmniSwitch CLI Reference Guide

Configures an IPv6 address for an IPv6 interface on a VLAN, configured tunnel, or a 6to4 tunnel. There 
are different formats for this command depending on the address type. 

ipv6 address ipv6_address /prefix_length [anycast] {if_name | loopback}

no ipv6 address ipv6_address [anycast] {if_name | loopback}

ipv6 address ipv6_prefix eui-64 {if_name | loopback}

no ipv6 address ipv6_prefix eui-64 {if_name | loopback}

IPv6 address.

The number of bits that are significant in the IPv6 address (mask). 
(3..128).

Indicates the address is an anycast address.

Append an EUI-64 identifier to the prefix.

Name assigned to the interface.

Configures the loopback interface.

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to delete an address.

• You can assign multiple IPv6 addresses to an IPv6 interface.

• No default value for prefix length.

• The “eui” form of the command is used to add or remove an IPv6 address for a VLAN or configured 

tunnel using an EUI-64 interface ID in the low order 64 bits of the address.

• To enable IPv6 routing you must first create a VLAN, then create an IPv6 interface on the VLAN. See 

 for information on creating VLANs.

• To route IPv6 traffic over and IPv4 network, you must create an IPv6 tunnel using the 

 command.