Alcatel-Lucent 6850-48 参照ガイド
IPv6 Commands
page 33-34
OmniSwitch CLI Reference Guide
September 2009
show ipv6 interface
Displays IPv6 Interface Table.
show ipv6 interface [if_name | loopback]
Syntax Definitions
if_name
Interface name. Limits the display to a specific interface.
loopback
Limits display to loopback interfaces.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• If you do not specify an interface name, all IPv6 interfaces are displayed.
• Specify an interface name (e.g., VLAN 12) to obtain a more detailed information about a specific inter-
face.
Examples
-> show ipv6 interface
Name IPv6 Address/Prefix Length Status Device
--------------------+----------------------------------------+---------+--------
smbif-5 fe80::2d0:95ff:fe12:f470/64 Active VLAN 955
212:95:5::35/64
212:95:5::/64
v6if-to-eagle fe80::2d0:95ff:fe12:f470/64 Disabled VLAN 1002
195:35::35/64
195:35::/64
V6if-6to4-137 2002:d423:2323::35/64 Active 6to4 Tunnel
2002:d423:2323::/64
v6if-tunnel-137 fe80::2d0:95ff:fe12:f470/64 Disabled Tunnel 2
137:35:35::35/64
137:35:35::/64 Active loopback
loopback ::1/128
output definitions
Name
Interface name. This is usually the VLAN on which the interface is
configured.
configured.
IPv6 Address/Prefix Length
IPv6 address and prefix length assigned to the interface. If an interface
has more than one IPv6 address assigned to it, each address is shown on
a separate line.
has more than one IPv6 address assigned to it, each address is shown on
a separate line.
Status
Interface status (e.g., Active/Inactive).
Device
The device on which the interface is configured (e.g., VLAN 955).