Alcatel-Lucent 6850-48 参照ガイド
IPv6 Commands
page 33-78
OmniSwitch CLI Reference Guide
September 2009
ipv6 rip jitter
Configures an offset value for RIPng updates. This is the maximum (positive or negative) value that can
be used to offset the update interval. For example, with an update interval of 30 seconds, and a jitter value
of 5 seconds, the RIPng update packet would be sent somewhere (random) between 25 and 35 seconds
from the previous update.
be used to offset the update interval. For example, with an update interval of 30 seconds, and a jitter value
of 5 seconds, the RIPng update packet would be sent somewhere (random) between 25 and 35 seconds
from the previous update.
ipv6 rip jitter value
Syntax Definitions
value
Time, in seconds, that a routing update is offset. Valid range is 0 to one-
half the updated interval value (e.g., if the updated interval is 30, the
range would be 0 - 300).
half the updated interval value (e.g., if the updated interval is 30, the
range would be 0 - 300).
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
As you increase the number of RIPng interfaces/peers, it is recommended that you increase the Jitter value
to reduce the number of RIPng updates being sent over the network.
to reduce the number of RIPng updates being sent over the network.
Examples
-> ipv6 rip jitter 10
Release History
Release 6.1; command was introduced.
Related Commands
MIB Objects
alaProtocolripng
alaRipngJitter
parameter
default
value
5
Configures the RIPng update interval.
Displays RIPng status and general configuration information.