Alcatel-Lucent 6850-48 参照ガイド
IPv6 Commands
page 33-86
OmniSwitch CLI Reference Guide
September 2009
ipv6 rip interface send-status
Configures IPv6 RIPng interface “Send” status. When this status is set to "enable", packets can be sent
from this interface. When it is set to "disable", packets will not be sent from this interface.
from this interface. When it is set to "disable", packets will not be sent from this interface.
ipv6 rip interface if_name send-status {enable | disable}
Syntax Definitions
if name
IPv6 interface name.
enable | disable
Interface “Send” status.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
RIPng must be loaded (
) and enabled (
)on the switch to send or receive pack-
ets on the interface.
Examples
-> ipv6 rip interface Test_Lab send-status enable
Release History
Release 6.1; command was introduced.
Related Commands
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceSendStatus
parameter
default
enable | disable
enable
Loads RIPng into memory.
Enables/disables RIPng on the switch.
Configures IPv6 RIPng interface “Receive” status.