Alcatel-Lucent 6850-48 参照ガイド
RDP Commands
OmniSwitch CLI Reference Guide
September 2009
page 35-15
show ip router-discovery
Displays the current RDP status and related statistics for the entire switch.
show ip router-discovery
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Each time RDP is enabled on the switch, all statistic parameter values are reset to zero for the new
session. For example, if the RDP uptime was 160000 seconds when RDP was last disabled, the uptime
starts out at zero the next time RDP is enabled.
starts out at zero the next time RDP is enabled.
• Use the show ip router-discovery interface command to display information about a specific RDP
interface.
Examples
-> show ip router-discovery
Status = Enabled,
RDP uptime = 161636 secs
#Packets Tx = 4,
#Packets Rx = 0,
#Send Errors = 0,
#Recv Errors = 0,
output definitions
Status
The status of RDP. Enabled allows RDP interfaces to advertise router
IP addresses; Disabled stops RDP traffic on all switch interfaces. Use
the
IP addresses; Disabled stops RDP traffic on all switch interfaces. Use
the
command to enable or disable RDP on the
switch.
RDP uptime
Indicates the amount of time, in seconds, that RDP has remained active
on the switch.
on the switch.
#Packets Tx
The number of RDP packets transmitted from all active RDP interfaces
on the switch.
on the switch.
#Packets Rx
The number of RDP packets received on all active RDP interfaces on
the switch.
the switch.
#Send Errors
The number of RDP packet transmission errors that have occurred.
#Recv Errors
The number of errors that occurred when receiving RDP packets.