Alcatel-Lucent 6850-48 参照ガイド
DHCP Relay Commands
page 36-46
OmniSwitch CLI Reference Guide
September 2009
ip helper boot-up enable
Specifies the type of packet to broadcast (BootP or DHCP) when automatic IP address configuration is
enabled for the switch.
enabled for the switch.
Note. Automatic IP address configuration only supports the assignment of a permanent IP address to the
switch. Make sure that the DHCP server is configured with such an address before using this feature.
switch. Make sure that the DHCP server is configured with such an address before using this feature.
ip helper boot-up enable {BOOTP | DHCP}
Syntax Definitions
BOOTP
Broadcasts a BOOTP formatted request packet.
DHCP
Broadcasts a DHCP formatted request packet.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
This command is only valid if automatic IP address configuration is already enabled for the switch.
Examples
-> ip helper boot-up enable DHCP
-> ip helper boot-up enable BOOTP
Release History
Release 6.1; command was introduced.
Related Commands
MIB Objects
iphelperStatTable
iphelperBootupPacketOption
parameter
default
BOOTP | DHCP
BOOTP
Enables or disables automatic IP configuration for the switch.