Alcatel-Lucent 6850-48 参照ガイド
OmniSwitch CLI Reference Guide
September 2009
page 37-1
37 RIP Commands
Routing Information Protocol (RIP) is an Interior Gateway Protocol (IGP) that uses hop count as its rout-
ing metric. RIP-enabled switches update neighboring switches by transmitting a copy of their own routing
table. The RIP routing table always uses the most efficient route to a destination, that is, the route with the
fewest hops and longest matching prefix.
ing metric. RIP-enabled switches update neighboring switches by transmitting a copy of their own routing
table. The RIP routing table always uses the most efficient route to a destination, that is, the route with the
fewest hops and longest matching prefix.
The switch supports RIP version 1 (RIPv1), RIP version 2 (RIPv2), and RIPv2 that is compatible with
RIPv1. It also supports simple and MD5 authentication, on an interface basis, for RIPv2.
RIPv1. It also supports simple and MD5 authentication, on an interface basis, for RIPv2.
The RIP commands comply with the following RFCs: RFC1058, RFC2453, RFC1722, RFC1723, and
RFC1724.
RFC1724.
MIB information for the RIP commands is as follows:
Filename:
RIPv2.mib
Module:
rip2
Filename:
AlcatelIND1Rip.mib
Module:
alaRipMIB
A summary of the available commands is listed here:
ip load rip
ip rip status
ip rip interface
ip rip interface status
ip rip interface metric
ip rip interface send-version
ip rip interface recv-version
ip rip force-holddowntimer
ip rip host-route
ip rip route-tag
ip rip interface auth-type
ip rip interface auth-key
ip rip update-interval
ip rip invalid-timer
ip rip garbage-timer
ip rip status
ip rip interface
ip rip interface status
ip rip interface metric
ip rip interface send-version
ip rip interface recv-version
ip rip force-holddowntimer
ip rip host-route
ip rip route-tag
ip rip interface auth-type
ip rip interface auth-key
ip rip update-interval
ip rip invalid-timer
ip rip garbage-timer