Alcatel-Lucent 6850-48 参照ガイド

RIP Commands

page 37-6

OmniSwitch CLI Reference Guide

Enables/disables a RIP interface. By default, a RIP interface is created in the disabled state. After creating 
a RIP interface, you must use this command to enable the interface.

ip rip interface {interface_name} status {enable | disable}

The name of the interface.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• You must first create a RIP interface by using the 

 command before enabling the inter-

face.

• You can create a RIP interface even if an IP router interface has not been configured. However, RIP 

will not function unless an IP router interface is configured with the RIP interface.

• For more information on VLANs and router ports, see 

-> ip rip interface rip-1 status enable

Release 6.1; command was introduced.
Release 6.2.1; ip_address parameter deprecated.