Alcatel-Lucent 6850-48 参照ガイド
IPX Commands
page 38-34
OmniSwitch CLI Reference Guide
September 2009
show ipx route
Displays the IPX routing table information.
show ipx route {network_number | vlan vlan}
Syntax Definitions
network_number
IPX network number.
vlan
VLAN that you want to display. Displays information on the specified
VLAN only.
VLAN only.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000
Usage Guidelines
• When entering the network number, you only need to enter the necessary characters and the system
will backfill the remainder of the number format.
• To display IPX routing table information for all networks/VLANs, use only the basic command syntax
(e.g., show ipx route).
Examples
-> show ipx route
Codes: C - Connected network, S - Static, R - RIP
4 routes
Type Network Next Hop [hops/delay] Next Hop VLAN
---- -------- ------------------------ ---------------------- ----
C 20 [0/1](ETHERNET_802.3), 20.00d0956a7ca2, 5
C 40 [0/1](ETHERNET_II), 40.00d0956a7ca2, 4
R eeee [1/2] via 20.0020daec9e7c, 4
R 55555555 [1/3] via 40.0000391b790c, 5
output definitions
Type
Network type (connected, static, and RIP).
Network
IPX network number.
Next Hop (hops/delay)
The first number in brackets is the hop count (the number of routers
between this node and the destination network). The second number is
the tick count (the number of ticks between this node and the destina-
tion network). If the route is directly connected, the media type is
shown in parenthesis. If the route was learned through routing proto-
cols, the media type is not shown.
between this node and the destination network). The second number is
the tick count (the number of ticks between this node and the destina-
tion network). If the route is directly connected, the media type is
shown in parenthesis. If the route was learned through routing proto-
cols, the media type is not shown.