Alcatel-Lucent 6850-48 参照ガイド
BFD Commands
OmniSwitch CLI Reference Guide
September 2009
page 39-23
ip ospf interface bfd-std drs-only
Establishes BFD sessions only with neighbors that are in the full state.
ip ospf interface interface-name bfd-std drs-only
Syntax Definitions
interface-name
The name of an existing OSPF interface.
Defaults
By default, BFD is enabled for DR neighbors only.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• The specified OSPF interface must be enabled to interact with BFD.
• The BFD status for OSPF must be enabled before OSPF can interact with BFD.
Examples
-> ip ospf interface int1 bfd-std drs-only
Release History
Release 6.3.4; command was introduced.
Related Commands
MIB Objects
alaOspfIfAugEntry
ospfIfIpAddress
alaOspfIfBfdDrsOnly
Enables or disables the BFD status for OSPF protocol.
Enables or disables BFD for all OSPF interfaces configured.
Enables or disables BFD for a specific OSPF interface.
Establishes BFD sessions with all neighbors of the corresponding
interface which are greater than or equal to “2-way” state.
interface which are greater than or equal to “2-way” state.