Alcatel-Lucent 6850-48 参照ガイド
VRRP Commands
page 40-16
OmniSwitch CLI Reference Guide
September 2009
vrrp preempt
Modifies the default preempt mode assigned to the virtual routers on the switch.
vrrp [preempt | no preempt]
Syntax Definitions
preempt
Specifies that a higher priority router may preempt a lower priority
master router by default.
master router by default.
no preempt
Specifies that a higher priority router may not preempt a lower priority
master router by default.
master router by default.
Defaults
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
• Modifying the default preempt mode will affect the mode assigned by default to any new virtual
routers that are created.
• To apply the new default value to the existing virtual routers, you must first disable the virtual routers,
then apply the new default value using the vrrp set command and enable the virtual routers again.
• If any of the virtual routers are running with their own configured value or group value, then that value
will take priority over the new default value. To override the configured value with the new default
value, you must first disable the virtual routers, then override the configured value using the vrrp set
command with the override option and enable the virtual routers again.
value, you must first disable the virtual routers, then override the configured value using the vrrp set
command with the override option and enable the virtual routers again.
Examples
-> vrrp preempt
-> vrrp no preempt
Release History
Release 6.3.1; command was introduced.
parameter
default
preempt | no preempt
preempt