Alcatel-Lucent 6850-48 参照ガイド

OSPF Commands

page 41-6

OmniSwitch CLI Reference Guide

Assigns a limit to the number of External Link-State Database (LSDB) entries that can be learned.

ip ospf extlsdb-limit limit

The maximum number of LSDB entries allowed on the router. The 
accepted value is any number greater than or equal to 1. If 0 is entered, 
there is no limit.

OmniSwitch 6850, 6855, 9000, 9000E

• This command allows you to set a limit to the number of external LSDBs learned by the router. An 

external LSDB is created when the router learns a link address that exists outside of its Autonomous 
System (AS).

• When the limit is set, and it is exceeded, older addresses that were previously learned are removed 

from the routing table to make room for the new external LSDB.

-> ip ospf extlsdb-limit 25

Release 6.1; command was introduced.

ospfGeneralGroup

ospfExtLsdbLimit

-1

Displays OSPF status and general configuration parameters.