Alcatel-Lucent 6850-48 参照ガイド
OSPF Commands
page 41-64
OmniSwitch CLI Reference Guide
September 2009
show ip ospf neighbor
Displays information on OSPF non-virtual neighbor routers.
show ip ospf neighbor [ip_address]
Syntax Definitions
ip_address
A 32-bit IP address of the neighboring router.
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
• This command is used to display all non-virtual neighbors of the OSPF router.
• See the Related Commands section below to modify the list.
Examples
-> show ip ospf neighbor
IP Address Area Id Router Id Vlan State Mode
----------------+----------------+----------------+----+-------+--------
1.1.1.1
255.255.255.255 0.0.0.0
0
Down Static
output definitions
IP Address
The IP address of the neighbor.
Area Id
A unique 32-bit value, such as an IP address, that identifies the neigh-
boring router in the Autonomous System.
boring router in the Autonomous System.
Router Id
The unique identification for the neighboring router.
VlanId
The VLAN corresponding to this interface on which the neighbor is
reachable.
reachable.
State
The state of the OSPF neighbor adjacency.
Mode
What type of neighbor, either Dynamic (learned) or Static.