Alcatel-Lucent 6850-48 参照ガイド
OSPF Commands
page 41-74
OmniSwitch CLI Reference Guide
September 2009
show ip ospf area
Displays either all OSPF areas, or a specified OSPF area.
show ip ospf area [area_id]
Syntax Definitions
area_id
A unique 32-bit value in IP address format.
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
• Allows you to view the details of a specified OSPF area.
• Not specifying an OSPF area will display all known areas for the OSPF router.
• See the Related Commands section below for information on modifying an area.
Examples
-> show ip ospf area
Area Id AdminStatus Type OperStatus
---------------+-------------+-------------+------------
1.1.1.1 disabled normal down
0.0.0.1 disabled normal down
-> show ip ospf area 0.0.0.0
Area Identifier = 1.1.1.1,
Admin Status = Disabled,
Operational Status = Down,
Area Type = normal,
Area Summary = Enabled,
Time since last SPF Run = 00h:00m:27s,
# of Area Border Routers known = 0,
# of AS Border Routers known = 0,
# of LSAs in area = 0,
# of SPF Calculations done = 0,
# of Incremental SPF Calculations done = 0,
# of Neighbors in Init State = 0,
# of Neighbors in 2-Way State = 0,
# of Neighbors in Exchange State = 0,
# of Neighbors in Full State = 0,
# of Interfaces attached = 0
Attached Interfaces = vlan-213