Alcatel-Lucent 6850-48 参照ガイド
IS-IS Commands
page 43-28
OmniSwitch CLI Reference Guide
September 2009
ip isis strict-adjacency-check
Enables or disables the adjacency check configuration on the router.
ip isis strict-adjacency-check {enable | disable}
Syntax Definitions
enable
Enables the adjacency check configuration on the router.
disable
Disables the adjacency check configuration on the router.
Defaults
By default, the adjacency check configuration is disabled.
Platforms Supported
OmniSwitch 6850, 9000, 9000E
Usage Guidelines
• When the adjacency check configuration is enabled, both routers have to run the same IP version only
in the IS-IS protocol to form an adjacency.
• When the adjacency check configuration is disabled, one common IP version running between two
routers is enough to form an adjacency in the IS-IS protocol.
Examples
-> ip isis strict-adjacency-check enable
Release History
Release 6.2.1; command was introduced.
Release 6.3.1; support for OmniSwitch 9000 added.
Release 6.3.1; support for OmniSwitch 9000 added.
Related Commands
MIB Objects
vRtrIsisTable
vRtrIsisStrictAdjacencyCheck
Displays the IS-IS status.