Alcatel-Lucent 6850-48 参照ガイド
IS-IS Commands
page 43-38
OmniSwitch CLI Reference Guide
September 2009
show ip isis database
Displays IS-IS LSP database information of the adjacent routers.
show ip isis database [{system_id system_id | lsp_id lsp_id}] [detail] [level {1 | 2}]
Syntax Definitions
system_id
The system ID of the router.
lsp_id
The LSP ID.
detail
Indicates that the output is displayed in a detailed manner.
level
Indicates the IS-IS level, either 1 or 2.
Defaults
By default the entire LSP database is displayed.
Platforms Supported
OmniSwitch 6850, 9000, 9000E
Usage Guidelines
• Use system-id or lsp-id parameter with this command to view specific LSP database information.
• Use the level parameter with this command to view the LSP database information of a particular level.
Examples
-> show ip isis database
Legends : P = The Partition repair bit is set
OV = The overload bit is set
ATT = The Attach bit is set
L1 = Specifies a Level 1 IS type
L2 = Specifies a Level 2 IS type
=================================================================
ISIS Database
=================================================================
LSP ID Sequence Checksum Lifetime Attributes
------------------------------------------------------------------
Displaying level-1 database
------------------------------------------------------------------
1720.2116.0051.00-00 0x44 0xb664 919 L1L2
level-1 LSP count : 1
Displaying level-2 database
------------------------------------------------------------------
1720.2116.0051.00-00 0x45 0xb465 1083 L1L2
level-2 LSP count : 1
=====================================================================