Alcatel-Lucent 6850-48 参照ガイド
BGP Commands
page 44-164
OmniSwitch CLI Reference Guide
September 2009
show ip bgp aggregate-address
Displays aggregate route status.
show ip bgp aggregate-address [ip_address ip mask]
Syntax Definitions
ip_address
The 32-bit IP address of the aggregate address.
ip_mask
The 32-bit subnet mask number that determines how many bits of the IP
address parameter denote the network number.
address parameter denote the network number.
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
This command displays a specific aggregate address, or all aggregate addresses on the router.
Examples
-> show ip bgp aggregate-address
Network Mask Summarize As-Set Admin state Oper state
---------------+---------------+---------+--------+-----------+----------
155.132.44.73 255.255.255.255 disabled disabled disabled not_active
192.40.6.0 255.255.255.255 disabled disabled disabled not_active
-> show ip bgp aggregate-address 192.40.6.0 255.255.255.255
Aggregate address = 192.40.6.0,
Aggregate mask = 255.255.255.255,
Aggregate admin state = disabled,
Aggregate oper state = not_active,
Aggregate as-set = disabled,
Aggregate summarize = disabled,
Aggregate metric = 0,
Aggregate local preference = 0,
Aggregate community string = 0:500 400:1 300:2
output definitions
Network or Aggregate address
The IP address for this aggregate route. This value is configured
through the
through the
command.
Mask or Aggregate mask
The mask for this aggregate route. This value is configured through the
Summarize or
Aggregate summarize
Aggregate summarize
Indicates whether aggregate summarization is enabled or disabled for
this aggregate route. This value is configured through the
this aggregate route. This value is configured through the
command.