Alcatel-Lucent 6850-48 参照ガイド
BGP Commands
OmniSwitch CLI Reference Guide
September 2009
page 44-235
show ipv6 bgp neighbors
Displays the configured IPv6 BGP peers.
show ipv6 bgp neighbors [ipv6_address]
Syntax Definitions
ipv6_address
The 128-bit IPv6 address of the BGP neighbor.
Defaults
By default, all the configured IPv6 BGP peers will be displayed.
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
Use the ipv6_address parameter to display the details of a specified IPv6 BGP peer.
Examples
-> show ipv6 bgp neighbors
Legends: Nbr = Neighbor
As = Autonomous System
Nbr address As Admin state Oper state BGP Id Up/Down
--------------------------+-----+-----------+------------+------------+---------
2001:100:3:4::1 30 enabled established 11.4.0.1 01h:42m:08s
fe80::200:57ff:fe28:7e89 10 enabled established 11.5.0.1 01h:40m:58s
-> show ipv6 bgp neighbors 2001:100:3:4::1
Neighbor address = 2001:100:3:4::1,
Neighbor autonomous system = 30,
Neighbor Admin state = enabled,
Neighbor Oper state = established,
Neighbor passive status = disabled,
Neighbor name = peer(2001:100:3:4::1),
Neighbor local address = 2001:100:3:4::10,
Neighbor EBGP multiHop = disabled,
Neighbor next hop self = disabled,
Neighbor Route Refresh = enabled,
Neighbor Ipv4 unicast = enabled,
Neighbor Ipv4 multicast = disabled,
Neighbor type = internal,
Neighbor auto-restart = enabled,
Neighbor route-reflector-client = disabled,
Neighbor confederation status = disabled,
Neighbor remove private AS = disabled,
Neighbor default originate = disabled,
Neighbor maximum prefixes = 5000,
Neighbor max prefixes warning = enabled,
# of prefixes received = 10,