Alcatel-Lucent 6850-48 参照ガイド

ページ / 3444
PIM Commands
page 45-26
OmniSwitch CLI Reference Guide
September 2009
ip pim state-refresh-interval
Sets the interval between successive State Refresh messages originated by a router.
ip pim state-refresh-interval seconds
Syntax Definitions
seconds
The interval between successive State Refresh messages, in seconds. 
Values may range from 0 to 65535.
Defaults
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
• This command is supported only in the dense mode.
• This value is used with both IPv4 PIM-DM and IPv6 PIM-DM.
Examples
-> ip pim state-refresh-interval 80
Release History
Release 6.1.1; command was introduced.
Related Commands
MIB Objects
alaPim
alaPimRefreshInterval
parameter
default
seconds
60
Enables or disables the PIM protocol on a specific interface.
Enables IPv6 PIM and configures the statistics.
Displays the status of the various global parameters for the PIM 
dense mode.
Displays the status of the various global parameters for the IPv6 
PIM dense mode.