Alcatel-Lucent 6850-48 参照ガイド
PIM Commands
OmniSwitch CLI Reference Guide
September 2009
page 45-51
show ip pim group-map
Displays the PIM group mapping table.
show ip pim group-map [bsr | static-rp | ssm | dense]
Syntax Definitions
N/A
Defaults
If the keywords bsr, static-rp, ssm, or dense are included in the command line, then only the entries that
were created by the specified origin are displayed.
were created by the specified origin are displayed.
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
• If static RP configuration is being used, this information is obtained from those static RP addresses that
are defined via the
command. As long as the RP addresses defined in the static RP set
are reachable, they will be added to the group mapping table.
• If the IP multicast groups are mapped to the mode SSM or DM, then the entries created by local SSM
address range configuration using the
command and local Dense Mode address
command are displayed.
• If the Bootstrap mechanism is being used, this information is obtained from received Candidate-RP
advertisements (when the local router is the BSR; when the local router is not the BSR, this informa-
tion is obtained from received Bootstrap messages).
tion is obtained from received Bootstrap messages).
Examples
-> show ip pim group-map
Origin Group Address/Pref Length RP Address Mode Precedence
---------+---------------------------+-------------+-----+-----------
BSR 224.0.0.0/4 172.21.63.11 asm 192
BSR 224.0.0.0/4 214.0.0.7 asm 192
Static 232.0.0.0/8 ssm
-> show ip pim group-map bsr
Origin Group Address/Pref Length RP Address Mode Precedence
---------+---------------------------+-------------+-----+-----------
BSR 224.0.0.0/4 172.21.63.11 asm 192
BSR 224.0.0.0/4 214.0.0.7 asm 192
-> show ip pim group-map static
Origin Group Address/Pref Length RP Address Mode Precedence
---------+---------------------------+-------------+-----+-----------
Static 232.0.0.0/8 ssm