Alcatel-Lucent 6850-48 参照ガイド

QoS Policy Commands

OmniSwitch CLI Reference Guide

page 53-59

Configures a source IP port number for a policy condition.

policy condition condition_name source ip port port[-port]

policy condition condition_name no source ip port

The name of the condition.

The TCP or UDP port number of the source address of the Layer 3 flow, 
in the range from 0–65535. A range of ports (separated by a hyphen) 
may be specified instead of a single port. 

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of the command to remove a source IP port from a condition; however, at least one 

classification parameter must be associated with a condition.

• The protocol (TCP or UDP) must be specified in the condition, either on the same command line or in 

a previous command. Use the ip protocol keywords. See the 

for more 

information.

• The same condition cannot specify a source IP port with a source TCP port, source UDP port, service, 

or service group.

-> policy condition cond1 ip protocol 6 source ip port 137

Release 6.1; command was introduced.

Applies configured QoS and policy settings to the current configuration. 

Configures an IP protocol for a policy condition.

Shows information about policy conditions configured on the switch.