Alcatel-Lucent 6850-48 参照ガイド

ページ / 3444
QoS Policy Commands
OmniSwitch CLI Reference Guide
September 2009
page 53-77
policy condition service
Configures a service for a policy condition.
policy condition condition_name service service_name
policy condition condition_name no service
Syntax Definitions
condition_name
The name of the condition.
service_name
The service name, configured through the policy service command.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Use the no form of the command to remove a service group from a condition; however, at least one 
classification parameter must be associated with a condition.
• A policy condition that specifies a service cannot also specify a service group, IP protocol, source IP 
port, or destination IP port.
Examples
-> policy condition cond12 service serv2
Release History
Release 6.1; command was introduced.
Related Commands
MIB Objects
alaQoSConditionTable
alaQoSConditionService
alaQoSAppliedConditionTable
alaQoSAppliedConditionService
Configures a service that may be used as part of a policy service group.
Applies configured global QoS and policy settings to the current config-
uration (changes will be active and stored in flash). 
Displays information about all particular policy services or a particular 
policy service configured on the switch.