Alcatel-Lucent 6850-48 参照ガイド

QoS Policy Commands

page 53-84

OmniSwitch CLI Reference Guide

Configures an IP protocol for a policy condition.

policy condition condition_name ip protocol protocol

policy condition condition_name no ip protocol

The name of the condition.

The protocol associated with the flow. The range is 0–255.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of the command to remove a protocol from a condition; however, at least one classifi-

cation parameter must be associated with a condition.

• If a source or destination port is specified (through the policy condition source ip port or policy 

condition destination ip port commands), the protocol must be specified.

• The same condition cannot specify an IP protocol with a service or service group.

-> policy condition cond4 ip protocol 6

Release 6.1; command was introduced.

6

Configures a source IP port number for a policy condition.

Configures a destination IP port number for a policy condition.

Applies configured QoS and policy settings to the current configuration. 

Shows information about policy conditions configured on the switch.