Alcatel-Lucent 6850-48 参照ガイド
QoS Policy Commands
OmniSwitch CLI Reference Guide
September 2009
page 53-165
show policy classify destination mac
Specifies a destination MAC address for a hypothetical packet to show how the QoS software in the
switch will handle the packet.
switch will handle the packet.
show policy classify {l2 | l3 multicast} [applied] destination mac mac_address
Syntax Definitions
l2
Uses the Layer 2 classifier for the hypothetical packet.
l3
Uses the Layer 3 classifier for the hypothetical packet.
multicast
Uses the multicast IGMP classifier for the hypothetical packet.
applied
Indicates that only applied policies should be examined.
mac_address
The destination MAC address of the Layer 2 flow (for example,
00:20:da:05:f6:23
00:20:da:05:f6:23
)
.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
Use the applied keyword to test only those policies that have been applied.
• Use the qos apply command to activate saved policies.
Examples
-> show policy classify l2 destination mac 00:20:da:05:f6:23
for more information about the potential screen display.
Release History
Release 6.1; command was introduced.