Alcatel-Lucent 6850-48 参照ガイド
QoS Policy Commands
page 53-180
OmniSwitch CLI Reference Guide
September 2009
show policy classify multicast ip
Specifies a multicast address for a hypothetical packet to show how the QoS software in the switch will
handle the packet.
handle the packet.
show policy classify {l2 | l3 | multicast} [applied] multicast ip ip_address
Syntax Definitions
l2
Uses the Layer 2 classifier for the hypothetical packet.
l3
Uses the Layer 3 classifier for the hypothetical packet.
multicast
Uses the multicast IGMP classifier for the hypothetical packet.
applied
Indicates that only applied policies should be examined.
ip_address
The multicast IP address (the address of the multicast stream).
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
Use the applied keyword to test only those policies that have been applied.
• Use the qos apply command to activate policies.
Examples
-> show policy classify multicast multicast ip 224.22.22.1
Packet headers:
L2:
*Port
:
0/0 (any)
-> 0/0 (any)
*MAC
:
000000:000000
-> 080020:D1E51
*VLAN
:
0
-> 0
*802.1p
: 0
L3/L4:
*Mcast
:
224.22.22.1
*IP
:
0.0.0.0
-> 0.0.0.0
*TOS/DSCP
: 0/0
Using pending multicast policies
Classify Multicast:
*No rule matched: (accept)
for information about the displayed fields.