Alcatel-Lucent 6850-48 参照ガイド
QoS Policy Commands
page 53-188
OmniSwitch CLI Reference Guide
September 2009
show policy classify source ip port
Specifies a source IP port for a hypothetical packet to show how the QoS software in the switch will
handle the packet.
handle the packet.
show policy classify {l2 | l3 | multicast} [applied] source ip port port
Syntax Definitions
l2
Uses the Layer 2 classifier for the hypothetical packet.
l3
Uses the Layer 3 classifier for the hypothetical packet.
multicast
Uses the multicast IGMP classifier for the hypothetical packet.
applied
Indicates that only applied policies should be examined.
port
The well-known port number for the desired service. For example, the
port number for Telnet is 23.
port number for Telnet is 23.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
Use the applied keyword to test only those policies that have been applied.
• Use the qos apply command to activate policies.
Examples
-> show policy classify l3 source ip port 80
for more information about the potential screen display.
Release History
Release 6.1; command was introduced.