Alcatel-Lucent 6850-48 参照ガイド

File Management Commands

page 7-30

OmniSwitch CLI Reference Guide

Performs a file system check, including diagnostic information in the event of file corruption.

fsck /flash [no-repair | repair]

Indicates that the file system check will be performed on the /flash 
directory. 

Performs only the file system check on the /flash directory.

Performs file system check on the /flash directory and also repairs any 
errors found on the file system.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• The file system check is performed on the /flash directory by default.

• Specifying the parameter repair along with the command performs the file system check and also 

repairs any errors found.The switch will display the errors found and specify those errors that have 
been repaired. If there are no errors found, then just the file system information is displayed.

• This command only applies to the primary and secondary CMM in an OmniSwitch chassis-based 

switch or the primary and secondary switch in an OmniSwitch stack.

-> fsck /flash no-repair

/flash/  - disk check in progress ...

/flash/  - Volume is OK

          total # of clusters:  29,758

           # of free clusters:  18,886

            # of bad clusters:  0

             total free space:  77,357,056

max contiguous free space:  55,451,648 bytes

                   # of files:  59

                 # of folders:  5

         total bytes in files:  44,357,695

             # of lost chains:  0

   total bytes in lost chains:  0