Alcatel-Lucent 6850-48 参照ガイド

IP Multicast Switching Commands

page 55-72

OmniSwitch CLI Reference Guide

Configures the expiry time of IPv6 multicast routers on the specified VLAN or on the system if no VLAN 
is specified.

ipv6 multicast [vlan vid] router-timeout [seconds]

VLAN on which to apply the configuration.

MLD router timeout in seconds. Valid range is 1 to 65535.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• IPv6 Multicast Switching and Routing must be enabled to set the MLD router timeout on the system 

and/or the specified VLANs. apply this configuration.

• If the MLD router timeout is already configured on the system, then the VLAN configuration will over-

ride the system's configuration.

• To restore the MLD router timeout to its default (i.e., 90 seconds) value on the system if no VLAN is 

specified, use ipv6 multicast router-timeout followed by the value 0
(e.g., ipv6 multicast router-timeout 0) or use only ipv6 multicast router-timeout (e.g., ipv6 multicast 
router-timeout).

• To restore the MLD router timeout to its default (i.e., 90 seconds) value on the specified VLAN, use 

ipv6 multicast vlan vid router-timeout followed by the value 0 
(e.g., ipv6 multicast vlan 2 router-timeout 0) or use only ipv6 multicast vlan vid router-timeout (e.g., 
ipv6 multicast vlan 2 router-timeout).

-> ipv6 multicast router-timeout 100

-> ipv6 multicast router-timeout 0

-> ipv6 multicast router-timeout

-> ipv6 multicast vlan 2 router-timeout 100

-> ipv6 multicast vlan 2 router-timeout 0

-> ipv6 multicast vlan 2 router-timeout

Release 6.1.1; command was introduced.

90