Alcatel-Lucent 6850-48 参照ガイド

ページ / 3444
OmniSwitch CLI Reference Guide
September 2009
page 18
OSPFv3 Commands
show ip ospf border-routers [area_id] [router_id] [tos] [gateway]
show ip ospf ext-lsdb [linkstate-id ls_id] [router-id router_id]
show ip ospf host [ip_address]
show ip ospf lsdb [area_id] [rtr | net | netsum | asbrsum] [linkstate-id ls_id] [router-id 
router_id]
show ip ospf neighbor [ip_address]
show ip ospf routes [ip_addr mask tos gateway]
show ip ospf virtual-link [router_id]
show ip ospf virtual-neighbor area_id router_id
show ip ospf area [area_id]
show ip ospf area area_id range [{summary | nssa} ip_address ip_mask]
show ip ospf area area_id stub
show ip ospf interface [interface_name]
show ip ospf restart
]
 [metric metric]
router
 router_id 
[dead-interval seconds] [hello-interval seconds] [retrans-interval seconds] [transit-delay 
seconds]
ype {normal | stub [default-metric metric
]}]
show ipv6 ospf host [ipv6_address]
show ipv6 ospf lsdb [area area_id] [rtr | net | netsum | asbrsum] [linkstate-id ls_id] [router-id 
router_id]
encrypt-key
 
encrypt-key} | none}
ip isis csnp-auth
no ip isis csnp-auth
ip isis hello-auth
no ip isis hello-auth
ip isis psnp-auth
no ip isis psnp-auth
ip isis lsp-lifetime seconds
no ip isis lsp-lifetime
ip isis lsp-wait {max-wait | initial-wait | second-wait} seconds
no ip isis lsp-wait {max-wait | initial-wait | second-wait}
ip isis spf-wait {max-wait seconds | initial-wait milliseconds| second-wait milliseconds}
no ip isis spf-wait {max-wait | initial-wait | second-wait}
ip isis summary-address {ip-prefix/mask | ip-prefix [/netmask]} {level-1 | level-2 | level-1/2}
no ip isis summary-address {ip-prefix/mask | ip-prefix [/netmask]}
ip isis overload [timeout seconds]
no ip isis overload [timeout]
ip isis overload-on-boot [timeout seconds]
no ip isis overload-on-boot [timeout seconds]
ip isis graceful-restart
no ip isis graceful-restart
ip isis graceful-restart helper {enable | disable}
ip isis system-wait-time time
no ip isis system-wait-time
ip isis strict-adjacency-check {enable | disable}