Alcatel-Lucent 6850-48 参照ガイド

SNMP Commands

OmniSwitch CLI Reference Guide

page 10-3

Adds a new SNMP station; modifies or deletes an existing SNMP station.

snmp station {ip_address | ipv6_address} {[udp_port] [username] [v1 | v2 | v3] [enable | disable]}

no snmp station {ip_address | ipv6_address} 

The IP address to which SNMP unicast traps will be sent.

The IPv6 address to which SNMP unicast traps will be sent.

A UDP destination port.

The user name on the switch or external server used to send traps to the 
SNMP station(s). 

The username specified here must match an 

existing user account name.

Specifies that traps are sent using SNMP version 1.

Specifies that traps are sent using SNMP version 2.

Specifies that traps are sent using SNMP version 3.

Enables the specified SNMP station.

Disables the specified SNMP station.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of the command to remove an existing SNMP station.

• The user name specified must match an existing user account name. 

• When adding an SNMP station, you must specify an IP address plus username parameters. For exam-

ple, the syntax snmp station 1.2.3.4 is not a valid command entry; however, snmp station 1.2.3.4 
username1 is a valid command entry.

• You can establish up to 50 SNMP sessions towards an OmniSwitch.

162