Alcatel-Lucent 6850-48 参照ガイド

Link Aggregation Commands

OmniSwitch CLI Reference Guide

page 12-3

Creates a static aggregate group between two switches. A static aggregate group contains static links.

static linkagg agg_num size size [name name] [admin state {enable | disable}]

no static linkagg agg_num

The number corresponding to the static aggregate group. Must be a 
unique integer in the range 0–31 (stackable products) or 0–127 (chassis-
based products).

The maximum number of links allowed in the aggregate group. Values 
may be 2, 4, or 8.

The name of the static aggregate group. May be any alphanumeric string 
up to 255 characters long. Spaces must be contained within quotes (e.g., 
“Static Group 1”).

Specifies that the static aggregate group is active and is able to aggre-
gate links.

Specifies that the static aggregate group is inactive and not able to 
aggregate links.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to remove a static aggregate group from the configuration.

• The maximum number of link aggregate groups allowed on the switch (static and dynamic combined) 

is 32 for stackable products and 128 for chassis-based products.

• Note that a maximum of 256 link aggregation ports are supported. The number of link aggregation 

ports per group will determine the maximum number of groups that can be configured. The table below 
provides some example configurations: 

enable