Alcatel-Lucent 6850-48 参照ガイド
Ethernet Ring Protection Commands
page 16-10
OmniSwitch CLI Reference Guide
September 2009
erp-ring wait-to-restore
Configures the wait-to-restore timer value for the Ring Protection Link (RPL) switch. This timer deter-
mines the number of minutes the RPL switch waits before returning the RPL ports to a blocked state after
the ERP ring has recovered from a link failure.
mines the number of minutes the RPL switch waits before returning the RPL ports to a blocked state after
the ERP ring has recovered from a link failure.
erp-ring ring_id wait-to-restore wtr_timer
no erp-ring ring_id wait-to-restore
Syntax Definitions
ring_id
An existing ERP ring ID number. The valid range is 1- 2147483647.
wtr_timer
The number of minutes to wait before restoring the RPL to a blocked
state. The valid range is 1-12.
state. The valid range is 1-12.
Defaults
By default, the wait-to-restore timer value is set to 5 minutes.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Use the no form of this command to set the timer back to the default setting of 5 minutes.
• The specified ERP ring ID must already exist in the switch configuration.
• This command applies only on a switch that serves as the RPL node for the ERP ring.
Examples
-> erp-ring 1 wait-to-restore 6
-> no erp-ring 1 wait-to-restore
Release History
Release 6.3.4; command was introduced.
Related Commands
MIB Objects
alaErpRingId
alaErpRingWaitToRestoreTimer
Configures an ERP ring.
Configures a Ring Protection Link (RPL) port connection.
Displays the ERP ring configuration for the switch.