Alcatel-Lucent 6850-48 参照ガイド
Ethernet Ring Protection Commands
OmniSwitch CLI Reference Guide
September 2009
page 16-17
show erp
Displays the ERP configuration information for all rings, a specific ring, or for a specific ring port.
show erp [ring ring_id | [port slot/port | linkagg agg_num]]
Syntax Definitions
ring_id
An existing ERP ring ID number. The valid range is 1- 2147483647.
slot/port
The slot number for the module and the physical port number on that
module.
module.
agg_num
The link aggregate ID number.
Defaults
By default, configuration information is displayed for all ERP rings in the switch configuration.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Enter a ring ID to display the configuration for a specific ring.
• Enter a ring port number or a link aggregate ID to display the configuration for a specific port or link
aggregate.
• The specified ring ID must already exist in the switch configuration.
Examples
-> show erp
Legends: * - Inactive Configuration
WTR - Wait To Restore
MEG - Maintenance Entity Group
Ring Ring Ring Ring Serv WTR Guard MEG Ring Ring
ID Port1 Port2 Status VLAN Timer Timer Level State Node
(min) (csec)
----------+------+------+---------+----+-----+-----+-----+-----------+--------
1 1/15 1/1 enabled 4094 3 50 2 idle rpl
2 6/7 4/1 enabled 4093 1 50 1 idle rpl
3 4/7 6/1 enabled 4092 1 50 3 idle rpl
4 4/8 6/23 enabled 4091 5 50 4 idle non-rpl
Total number of rings configured = 4
-> show erp ring 1
Legend: * - Inactive Configuration
Ring Id : 1,
Ring Port1 : 1/15,