Alcatel-Lucent 6850-48 参照ガイド

CMM Commands

page 1-16

OmniSwitch CLI Reference Guide

Shows the directory from where the switch was booted.

N/A

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E 

• Once a switch has booted and is running, it will run either from the working or certified directory. If 

running from the certified, changes made to the running configuration using CLI commands cannot be 
saved. A switch must be running from the working directory in order to save the current running 
configuration.

• This command can also be used on the secondary CMM.

The following is an example of the display on OmniSwitch 9000 switches:

-> show running-directory

CONFIGURATION STATUS

   Running CMM              : PRIMARY,

   CMM Mode                 : MONO CMM,

   Current CMM Slot         : A,

   Running configuration    : WORKING,

   Certify/Restore Status   : CERTIFY NEEDED

SYNCHRONIZATION STATUS

   Running Configuration    : SYNCHRONIZED,

   NIs Reload On Takeover   : NONE

The following is an example of the display on OmniSwitch 6850 Series switches: