Alcatel-Lucent 6850-48 参照ガイド
Source Learning Commands
page 17-6
OmniSwitch CLI Reference Guide
September 2009
mac-address-table vpls permanent mesh-sdp
Configures a static MAC address and associates that address with the specified Service Distribution Point
(SDP) ID binding with the specified Virtual Private LAN Service (VPLS).
(SDP) ID binding with the specified Virtual Private LAN Service (VPLS).
mac-address-table vpls service-id permanent mac-address mesh-sdp sdp-id[:vc-id]
no mac-address-table vpls service-id permanent mac-address
no mac-address-table vpls service-id learned [mesh-sdp sdp-id[:vc-id]] mac-address
Syntax Definitions
service-id
An existing VPLS ID number.
mac-address
A 48-bit MAC address (aa:bb:cc:dd:ee:ff). Valid addresses are any non-
broadcast, non-multicast MAC, and non-IEEE reserved addresses.
broadcast, non-multicast MAC, and non-IEEE reserved addresses.
sdp-id
An existing SDP ID number that is bound to the specified service ID
number.
number.
vc-id
Optional. The VC ID number appended to the specified SDP ID
number.
number.
learned
Specifies that the MAC address is a dynamically learned address. This
option is only available with the no form of this command.
option is only available with the no form of this command.
Defaults
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
• Use the no form of this command to remove the configured static MAC from the source learning FDB.
• The specified VPLS ID and SDP ID must already exist in the VPLS configuration for the switch. See
the “VPLS Commands” chapter in this guide for information about how to configure a VPLS and SDP.
• Static MACs associated with SDPs are classified as remote MACs. A remote MAC is used by the asso-
ciated VPLS so that MAC addresses are not learned on the edge device.
• A MAC address can participate in only one static MAC address entry (local or remote) for a specific
VPLS.
• Static MAC addresses configured on one edge device are not propagated to other edge devices associ-
ated with the same VPLS instance. Each edge device has an independent forwarding database for the
associated VPLS.
associated VPLS.
parameter
default
vc-id
service-id value