Alcatel-Lucent 6850-48 参照ガイド

Port Mobility Commands

page 20-12

OmniSwitch CLI Reference Guide

Defines a binding MAC-port rule for an existing VLAN. This rule restricts VLAN membership to a device 
that matches all criteria of the rule. Device frames received on the specified mobile port must contain a 
source MAC address that matches the MAC address specified in the rule. 

vlan vid binding mac-port mac_address slot/port

vlan vid no binding mac-port mac_address

VLAN ID number (1–4094).

Source MAC address (e.g., 00:00:39:59:f1:0c). 

The slot number for the module and the physical mobile port number on 
that module (e.g., 3/1 specifies port 1 on slot 3).

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to delete a binding MAC-port rule from the specified VLAN. It is 

only necessary to enter a MAC address to identify which rule to delete; the slot/port is not required.

• If only the frame’s source MAC address matches the MAC address specified in this rule, a binding rule 

violation occurs and the device frame is blocked and its port is not assigned to the VLAN. There is no 
further attempt to compare the frame to other VLAN rules.

• If only the frame’s port matches the port specified in this rule, the frame is allowed but the port is still 

not assigned to the VLAN. The frame is then compared to other VLAN rules for possible matches.

• A binding rule applies to a specific device. Therefore, a separate binding rule is required for each 

device.

• Binding MAC-port rules take precedence over all other rules, except binding MAC-port-protocol and 

binding MAC-IP-port rules. 

• Rules are only assigned to existing VLANs. Use the vlan command to create a new VLAN.

-> vlan 10 binding mac-port 00:00:39:59:0a:0c 5/1

-> vlan 20 no binding mac-port 00:00:39:4f:f1:22

Release 6.1; command was introduced.