Alcatel-Lucent 6850-48 参照ガイド

Port Mobility Commands

page 20-22

OmniSwitch CLI Reference Guide

Defines an IPX network address rule for an existing VLAN. If a device sends traffic that matches the IPX 
network address and encapsulation specified in the rule, the device and its mobile port will join the rule’s 
VLAN. 

vlan vid ipx ipx_net [e2 | llc | snap | novell]

vlan vid no ipx ipx_net

VLAN ID number (1–4094).

IPX network address consisting of up to eight hex characters 
(e.g., A010590C, B030210A). If less than eight hex digits are entered, 
the entry is prefixed with zeros to equal eight digits.

Enter e2 to specify Ethernet-II encapsulation.

LLC (802.2) encapsulation.

SNAP encapsulation.

Novell Raw (802.3) encapsulation.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to delete an IPX network address rule from the specified VLAN. It is 

only necessary to enter the IPX network address to identify which rule to delete; the encapsulation is 
not required.

• Specify e2, llc, snap, or novell-raw to identify the IPX encapsulation the device is going to use. If 

there is a mismatch and IPX traffic is routed, connectivity with the IPX server may not occur.

• This rule only applies to those devices that already have an IPX network address configured with an 

encapsulation that matches the encapsulation specified for the rule.

• Network address rules take precedence behind DHCP, binding, and MAC address rules.

• To remove an IPX network address rule, it is not necessary to specify the IPX encapsulation value.

• Rules are only assigned to existing VLANs. Use the vlan command to create a new VLAN.

e2