Alcatel-Lucent 6850-48 参照ガイド

ページ / 3444
VLAN Management Commands
page 21-10
OmniSwitch CLI Reference Guide
September 2009
vlan router ipx
Defines an IPX router interface to enable IPX routing on a VLAN. Defining an IPX router interface allows 
VLAN traffic to communicate with traffic from other IPX router VLANs. Without a router interface, traf-
fic is bridged within the VLAN or across connections to the same VLAN on other switches.
vlan vid router ipx ipx_net [rip | active | inactive | triggered] [e2 | llc | snap | novell] [timeticks ticks]
vlan vid no router ipx
Syntax Definitions
vid
An existing VLAN ID number (1–4094).
ipx_net
IPX network address consisting of eight hex characters (e.g. 0000590c, 
0000210a). If less than eight hex digits are entered, the entry is prefixed 
with zeros to equal eight digits.
rip
RIP updates are processed.
active
RIP and SAP updates are processed.
inactive
RIP and SAP updates are not processed, but router interface remains 
active.
triggered
RIP and SAP information is broadcast only when there are updates.
e2
Enter e2 or ethernet2 to specify Ethernet-II encapsulation.
novell
Novell Raw (802.3) encapsulation.
llc
LLC (802.2) encapsulation.
snap
SNAP encapsulation.
ticks
A 16-bit value (0–65535) that specifies the number of ticks for IPX 
delay time. A tick is approximately 1/18th of a second.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
parameter
default
rip | active | inactive | triggered active
e2 | llc | snap | raw
e2
ticks
0