Alcatel-Lucent 6850-48 参照ガイド
VLAN Stacking Commands
OmniSwitch CLI Reference Guide
September 2009
page 23-27
ethernet-service uni uni-profile
Associates a VLAN Stacking User Network Interface (UNI) profile with a UNI port.
ethernet-service uni {slot/port1[-port2] | agg_num} uni-profile uni-profile-name
Syntax Definitions
slot/port1
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
module (e.g., 3/1 specifies port 1 on slot 3).
-port2
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
agg_num
The link aggregate ID number (0–31).
uni-profile-name
Alphanumeric string of up to 32 characters. Use quotes around string if
the profile name contains multiple words with spaces between them
(e.g., “Alcatel-Lucent Engineering”).
the profile name contains multiple words with spaces between them
(e.g., “Alcatel-Lucent Engineering”).
Defaults
The default profile (default-uni-profile) is used to process control packets ingressing on a UNI port. This
profile is assigned at the time a port is configured as a VLAN Stacking UNI.
profile is assigned at the time a port is configured as a VLAN Stacking UNI.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• This UNI specified with this command must already exist in the switch configuration.
• To change the profile associated with a UNI port, use this command and specify a different profile
name than the one currently associated with the port. The last profile associated with the port, is the
profile that is applied to UNI port traffic.
profile that is applied to UNI port traffic.
• To change the profile associated with a UNI port back to the default profile, enter “default-uni-profile”
with this command.
Examples
-> ethernet-service uni 1/3 uni-profile uni_1
-> ethernet-service uni 2/10-15 uni-profile default-uni-profile
-> no ethernet-service uni 1/3 uni-profile uni_1
Release History
Release 6.3.1; command was introduced.