AvMap ekp iii c ユーザーズマニュアル

Approach Data Procedures

WARNING:

The EKP III C is not certified for use as the only navigation device during Instrument Flight

Rules as established by the FAA. Instrument approach points displayed in the unit are for information only and do
not establish authority for a pilot to fly the IFR approach procedure in actual instrument flying conditions. For IFR
flight. The final “Approach Segment & Missed Approach Point” the EKP is to be used strictly as a monitoring
instrument only.

An approach procedure is a series of pre-determined maneuvres for the orderly transfer of an air-

craft, under instrument flight conditions, from the beginning of the initial approach to a point

from which a safe landing may be made visually. Generally, the approach pattern and procedure is

not chosen until arrival in close proximity of the destination airport, since conditions may change

on route. To activate an “Approach” it is necessary to have an active “Flight Plan” or “GOTO”.

For each airport with at least one published final approach, there exists one or more named

approach procedures. Each approach procedure can be related to a runway and to nearby

NavAids (such as ILS, VOR, NDB, GPS...).

9.1 APPROACH FROM THE MOVING MAP

NOTE

You must start with an empty flight plan..

While navigating or planning in the moving map screen, the pilot will not be able to establish

an approach on a flight plan, without changing into the Flight Plan mode, but can place the cur-

sor over the selected airport. To display the quick data box press:

‘ENTER’ 1 sec + ‘ENTER’ (for detailed information).

The detailed information on the airport will be displayed, beginning with the gen-

eral information and frequencies. By pressing the left arrow, the approaches for the chosen

airport will display in the box and the bearing for the viewed approach will display on the

moving map. By continuing to press the left arrow the other approaches for the airport will

display, the last bearing for the last approach viewed will become white on the moving map

and the bearing for the viewed approach will be displayed in black on the moving map.

EKP III USER MANUAL