Genz-Benz ml 200-210t ユーザーガイド
POWER INPUT –
The ML 200 is shipped from the factory with a standard IEC type power inlet
connector and the appropriate power cable for the market the amplifier was shipped to. The toroidal
power transformer is a universal input (115/230 volt, 50/60 Hz) with a voltage selector switch located
above the inlet connector. Be sure that this switch is in the correct position (matching your local power
system) BEFORE connecting the ML 200 to the power source. There is an AC mains fuse (with a
spare fuse included!) located in the small slide out tray on the IEC power inlet connector. Always
replace with the correct value fuse as indicated on the fuse chart located on the back of the amplifier.
power transformer is a universal input (115/230 volt, 50/60 Hz) with a voltage selector switch located
above the inlet connector. Be sure that this switch is in the correct position (matching your local power
system) BEFORE connecting the ML 200 to the power source. There is an AC mains fuse (with a
spare fuse included!) located in the small slide out tray on the IEC power inlet connector. Always
replace with the correct value fuse as indicated on the fuse chart located on the back of the amplifier.
CABINET DESIGN –
The three combo models feature our unique M-Line shape that allows the combo
to be used in the upright position or laid back to the personal monitor position. USE CAUTION WHEN
SET IN THE UPRIGHT POSITION SO DIRECT PRESSSURE IS NOT APPLIED ON THE TOP-REAR
OF THE CABINET. THIS COULD CAUSE THE COMBO TO TIP BACKWARDS.
SET IN THE UPRIGHT POSITION SO DIRECT PRESSSURE IS NOT APPLIED ON THE TOP-REAR
OF THE CABINET. THIS COULD CAUSE THE COMBO TO TIP BACKWARDS.
SPEAKER DESIGN –
All combo models feature our tried and true high output woofers and conical
compression bullet tweeter. All three combos are configured to be 8 ohm impedance and these
combos come from the factory set to produce 200 watts from the ML DUAL OUTPUT DESIGN power
amp.
combos come from the factory set to produce 200 watts from the ML DUAL OUTPUT DESIGN power
amp.
CAUTION!
•
Never set an amplifier on anything that will tip over or collapse under its weight.
•
These amplifiers are capable of producing sound pressure levels that may cause hearing loss.
•
There are no user serviceable parts inside these units. Always consult a qualified repair facility for
service.
WARNING!
•
The use and operation of this device constitutes an agreement of full release of any and all liability
connected with it’s use. Only persons familiar with the operation of high-powered audio equipment
should attempt to operate this device.
should attempt to operate this device.
•
In addition, by use of this device, the user agrees to hold Genz Benz Enclosures, Inc. and it’s
designers, sales agents and all other affiliates and related parties harmless in the event of any
accident, injury, damage or loss resulting from such use.
accident, injury, damage or loss resulting from such use.
•
Manufacturer’s sole responsibility is to provide a warranty on the specified performance of the
product under normal operating conditions for a period of 3 years.
WARRANTY:
•
Genz Benz Enclosures, Inc. warrants the model ML 200 to be free from defects in materials and
workmanship for a period of 3 years from the date of purchase, when purchased from an authorized
Genz Benz dealer.
Genz Benz dealer.
•
This warranty does not cover normal wear and tear incurred from the normally designed use of the
product.
•
This warranty is effective only if a copy of the original sales receipt is presented at the time of
warranty service
•
This limited warranty is completely transferable to any subsequent buyer as long as the original
sales receipt is also transferred to such subsequent buyer.
•
All warranty service must be performed by a Genz Benz authorized service center.
•
Before returning any unit for service, a returned merchandise authorization number (RMA#) must be
obtained by calling 480-941-0705.