Genz-Benz td-742 ユーザーガイド
TD-742
TUBE DRIVER AMP
FRONT PANEL FEATURES
(left to right)
TUBE DRIVE SWITCH — Selects either TUBE Channel (up), or CLEAN Channel (down). Red LED indicates Tube chan-
nel is on. Footswitch jack insertion (rear panel) cancels the operation of this switch.
INPUT JACK — Wide-range input allows plenty of headroom for all types of guitars.
TUBE DRIVE — Adjusts the amount of gain that drives the tube. Careful attention has been given to produce the most
overdrive/sustain possible without creating unnecessary noise and feedback.
RED LED — Indicates that the Tube Drive channel has been selected.
TUBE MASTER — Adjusts the amount of output volume from the Tube Drive Channel.
CLEAN GAIN — Adjusts gain level of clean channel. Extremely warm tubey tonality is produced thanks to the tube pre-
amp and MosValve power section. Lows are especially well-balanced.
HI, MID, LO — Classic, passive 3-band E.Q. to enhance the Tube Driver's unique tonal response.
Frequencies: Hi 3.5 KHz (upper shelving)
MID 800 Hz (center)
LO 150 Hz (lower shelving)
REVERB — Adjusts amount of reverb signal mixed into the output. Reverb can be cancelled anytime by the footswitch,
or by turning the control to "0".
HEADPHONE — Standard 1/4” stereo headphone. Use 8 ohm or higher impedance.
POWER — Supplies mains power to the amp. Be certain that the proper voltage is supplied to the amp. The proper volt-
age for your unit is indicated just below the fuse holder on the rear panel.
nel is on. Footswitch jack insertion (rear panel) cancels the operation of this switch.
INPUT JACK — Wide-range input allows plenty of headroom for all types of guitars.
TUBE DRIVE — Adjusts the amount of gain that drives the tube. Careful attention has been given to produce the most
overdrive/sustain possible without creating unnecessary noise and feedback.
RED LED — Indicates that the Tube Drive channel has been selected.
TUBE MASTER — Adjusts the amount of output volume from the Tube Drive Channel.
CLEAN GAIN — Adjusts gain level of clean channel. Extremely warm tubey tonality is produced thanks to the tube pre-
amp and MosValve power section. Lows are especially well-balanced.
HI, MID, LO — Classic, passive 3-band E.Q. to enhance the Tube Driver's unique tonal response.
Frequencies: Hi 3.5 KHz (upper shelving)
MID 800 Hz (center)
LO 150 Hz (lower shelving)
REVERB — Adjusts amount of reverb signal mixed into the output. Reverb can be cancelled anytime by the footswitch,
or by turning the control to "0".
HEADPHONE — Standard 1/4” stereo headphone. Use 8 ohm or higher impedance.
POWER — Supplies mains power to the amp. Be certain that the proper voltage is supplied to the amp. The proper volt-
age for your unit is indicated just below the fuse holder on the rear panel.
OWNER’S MANUAL