Intellinet 522496 ユーザーガイド
6
3. SETUP & CONNECTIONS
OVERVIEW
This section will show you how to connect the Network Storage Adapter to your network.
Because the Network Storage Adapter uses the TCP/IP protocol to communicate with other
devices on the network, be sure this is installed on the computer you will use to configure the
Network Storage Adapter. Refer to Windows help for more information on TCP/IP installation.
HARDWARE INSTALLATION
1. Connect one end of the Ethernet cable to the Network Storage Adapter and the other end to
your Ethernet switch or computer.
2. Connect USB devices to the Network Storage Adapter.
3. Connect the power adapter to the rear socket of the Network Storage Adapter, then into the
wall outlet. If power is present, the Network Storage Adapter will proceed with its normal
power-on sequence. The Network Storage Adapter self-test and boot-up sequences will be
completed within five seconds. Once the Power LED is flashing on the front panel, the unit is
ready.
SETUP & CONNECTIONS
522496_man.dlrevL4C.indd 6
6/28/06 9:11:52 AM