Printronix L5020 ユーザーズマニュアル
Chapter 4
Consumables Replacement
122
8.
After installing the drum plate, visually verify good electrical
contact between the copper grounding clip and the end of the
drum shaft.
Alternatively, measure the resistance. Connect one lead of an
ohmmeter to the bracket on the drum plate, and touch the other
lead to the edge of the drum. Normal resistance should be 0
contact between the copper grounding clip and the end of the
drum shaft.
Alternatively, measure the resistance. Connect one lead of an
ohmmeter to the bracket on the drum plate, and touch the other
lead to the edge of the drum. Normal resistance should be 0
Ω
.
9.
Install the developing unit.
10. Raise the transport unit by turning the green lever on the
transport unit to the right.
11. Close the waste toner recovery unit and ensure that it latches.
12. Close the printer upper doors.
Proper Disposal Of A Drum Unit
Federal regulations prohibit inappropriate disposal of laser print
drums. Dispose of used drums by shipping them to one of the
following organizations:
drums. Dispose of used drums by shipping them to one of the
following organizations:
Within U.S.A.
U.S. Fuji Electric, Inc.
240 Circle Drive N.
Piscataway, NJ 08854
Attn: Rod Storm
Phone: (732) 560-9410
U.S. Fuji Electric, Inc.
240 Circle Drive N.
Piscataway, NJ 08854
Attn: Rod Storm
Phone: (732) 560-9410
Outside U.S.A.
Fuji Distribution Europe B.V.
Attn: Mr. Asada
Leisteen 7,2132 ME Hoofddorp,
The Netherlands.
TEL: 20-6534790
Fuji Distribution Europe B.V.
Attn: Mr. Asada
Leisteen 7,2132 ME Hoofddorp,
The Netherlands.
TEL: 20-6534790