Printronix SL5000r ユーザーズマニュアル
154
Chapter
3
PRINTER CONTROL
Set Lock Key
Normally, to lock or unlock the printer menu, the
↓ and ↵ keys are pressed at
the same time. The Set Lock Key parameter lets you choose different keys to
lock or unlock the printer menu. You may choose almost any group of keys as
the new lock and unlock keys. You cannot use the
lock or unlock the printer menu. You may choose almost any group of keys as
the new lock and unlock keys. You cannot use the
↵ key or any key
combinations which are already used for another function. There is no limit to
how many keys can be selected.
how many keys can be selected.
To set the new lock key:
1.
Go to the PRINTER CONTROL main menu and select “Set Lock Key.”
2.
Press
↵. The display reads, “Select a new lock key.”
3.
Press the combination of keys that you want to be the new lock key. Make
sure you press all keys selected at the same time.
sure you press all keys selected at the same time.
4.
If the selection is valid, the display will read, “Enter the new lock key
again.” Press the same combination of keys a second time. If the
selection is invalid, the display will read, “Invalid key selection.” Return to
step 2 and start over.
again.” Press the same combination of keys a second time. If the
selection is invalid, the display will read, “Invalid key selection.” Return to
step 2 and start over.
5.
If the new lock key combination is entered again correctly, the display will
read, “Lock key has been changed.” If it was entered incorrectly, the
display will read, “Validation failed.” Start over at step 1.
read, “Lock key has been changed.” If it was entered incorrectly, the
display will read, “Validation failed.” Start over at step 1.
6.
After entering the new lock combination successfully, press the PAUSE
key to put the printer back online.
key to put the printer back online.
NOTE: The new lock combination will remain even if the printer is powered
off and back on.
Ptx Setup Parse
•
Enable. Will parse and execute the PTX SETUP commands.
•
Ignore. Will parse the PTX SETUP commands but not act on them.
•
Disable. Will not parse the PTX SETUP commands so they will print out
as text.
as text.
The factory default is Enable.
PJL Control
•
Enable. Will parse and execute the PJL commands.
•
Disable. Will not parse the PJL commands; they will not print out as text.
The factory default is Enable.
Glob Mem Adjust
This menu allows you to adjust the ratio of global memory allocated to label
size versus PGL forms, fonts, and logos. For example, when using short
labels, you can allocate more memory to forms, fonts, and logos by increasing
the Glob Mem Adjust value.
size versus PGL forms, fonts, and logos. For example, when using short
labels, you can allocate more memory to forms, fonts, and logos by increasing
the Glob Mem Adjust value.
The amount of installed DRAM is 32 (MB). The range is from 0 to 12160
KBytes and the default is 9120 KBytes.
KBytes and the default is 9120 KBytes.