Printronix P5000LJ 参照マニュアル
84
Chapter
3
Configuring the P-Series Emulation with Control Codes
Character Set Select: ECMA Latin 1 Extended
ASCII Code SFCC OSET;
n
Purpose
Selects the print mode and pitch at which the extended
characters will print.
characters will print.
OSET is valid
only when the ECMA Latin 1 character set has
been selected from the control panel. OSET will be ignored if the
IBM PC, Multinational, or DEC Multinational Character Sets are
active.
IBM PC, Multinational, or DEC Multinational Character Sets are
active.
Discussion
n ranges from 0 through 12 (hex 00 through 0B) to select the
print mode/pitch combinations available from Table 20. All other
values will result in an error message.
print mode/pitch combinations available from Table 20. All other
values will result in an error message.
Extended characters will print at the print mode and pitch
selected by the OSET command, even if that mode and pitch
differs from the currently selected print mode and pitch. If the
print mode differs between the extended and primary characters,
the first character in the data stream selects the print mode at
which that line will print. Different pitches can be printed on the
same line.
selected by the OSET command, even if that mode and pitch
differs from the currently selected print mode and pitch. If the
print mode differs between the extended and primary characters,
the first character in the data stream selects the print mode at
which that line will print. Different pitches can be printed on the
same line.
Table 20. Print Modes/Pitches Available Using P-Series OSET (ECMA
Latin 1, Extended Character Set Only)
n
Print Mode/Pitch Select
0
Barcode DP 10 cpi
1
Multinational DP 10 cpi
2
Multinational DP 12 cpi
3
Multinational NLQ 10 cpi
4
Greek DP 10 cpi
5
Greek DP 12 cpi
6
Greek NLQ 10 cpi
7
Graphics DP 10 cpi
8
Graphics NLQ 10 cpi
9
Scientific DP 10 cpi
10
Scientific DP 12 cpi
11
Scientific NLQ 10 cpi
12
Multinational at Primary Character Set Mode and Pitch