Printronix P5000LJ 参照マニュアル
Forms Length Set (Lines)
93
Forms Length Set (Lines)
ASCII Code SFCC LINES;
n
Purpose
Sets the length of a form (paper) in lines.
where
n = 1 through 192 (hex 01 through C0) specify the number of
lines per page at the current line spacing.
lines per page at the current line spacing.
Discussion The forms length is set to the number of lines defined by the
quotient of
n and the current line spacing so that the units are in
inches. In LINES mode, the maximum form length is 24 inches,
and
and
n values in excess of 24 inches will cause an error
message.
If the calculated forms length in lines is not an exact multiple of
the target machine dot size, the forms length value will be
adjusted down to the next possible multiple.
the target machine dot size, the forms length value will be
adjusted down to the next possible multiple.
If the VFU is enabled and loaded, this command is ignored.
Line Feed
ASCII Code LF
Hex Code
0A
Dec Code
10
Purpose
Prints the data in the buffer (if any) and advances the vertical
character position one line at the current line space setting.
character position one line at the current line space setting.
Discussion If configured for LF equals new line (LF=CR+LF), the logical
print head is positioned at character column 1 of the new line.
Otherwise, the logical print head does not move when
configured for LF function only (LF=LF ONLY). The LF function
cancels all single line print attributes such as double high
(elongated) and double wide (expanded) characters.
Otherwise, the logical print head does not move when
configured for LF function only (LF=LF ONLY). The LF function
cancels all single line print attributes such as double high
(elongated) and double wide (expanded) characters.
This code is always configured for LF=CR+LF in the P-Series
protocol.
protocol.
In the P-Series Even Dot Plot mode (high density graphics), the
LF code does not cause paper position motion; the data in the
buffer is plotted and the logical print head is positioned at
character column 1 in anticipation of the Odd Dot Plot control
code to complete high density graphic plotting.
LF code does not cause paper position motion; the data in the
buffer is plotted and the logical print head is positioned at
character column 1 in anticipation of the Odd Dot Plot control
code to complete high density graphic plotting.
In the P-Series Odd Dot Plot mode (normal density graphics),
the LF code plots the data in the buffer, advances the paper
position a single dot row at the current vertical dot density, and
positions the logical print head at character column 1.
the LF code plots the data in the buffer, advances the paper
position a single dot row at the current vertical dot density, and
positions the logical print head at character column 1.