Printronix l7032 参照マニュアル
Reset
135
Example
The following sample command illustrates Printronix plotting,
plotting a line of arrows using the data shown in Table 17.
plotting a line of arrows using the data shown in Table 17.
^PY^-^F^-
^QC4,C4,C4,C4,C4,C4,C4,C4,C4,C4^*
^QC2,C2,C2,C2,C2,C2,C2,C2,C2,C2^*
^QFF,FF,FF,FF,FF,FF,FF,FF,FF,FF^*
^QFF,FF,FF,FF,FF,FF,FF,FF,FF,FF^*
^QC2,C2,C2,C2,C2,C2,C2,C2,C2,C2^*
^QC4,C4,C4,C4,C4,C4,C4,C4,C4,C4^*
^O^-^PN^-
Reset
NOTE: The Reset command is not supported on L7032 printers.
Purpose
Resets VGL to the current user defined configuration.
Mode
Graphics with a Standard Graphics Command selected
Format
(cc) @ R (cc)-
(cc)
Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your VGL con-
figuration.
(SFCC). Enter the specific SFCC for your VGL con-
figuration.
@
Specifies one of the @ commands. Enter @ to
begin an @ command function.
begin an @ command function.
R
Specifies the Reset command. Enter R to reset the
printer to the current user defined configuration.
printer to the current user defined configuration.
(cc)-
Graphics Mode CR. Enter the SFCC for your VGL
configuration immediately followed by - to end the
command sequence.
configuration immediately followed by - to end the
command sequence.
Comments
The Reset command prints any pending page then resets VGL to
the current user defined configuration (last loaded configuration
plus any front panel changes). This may not be the same
configuration used to power-up the printer if the front panel
changes were made and not saved to flash memory. VGL then
restarts as if just powered up (no dynamic forms in form library,
character substitution sets reset, starts printing in upper left
corner, etc.).
the current user defined configuration (last loaded configuration
plus any front panel changes). This may not be the same
configuration used to power-up the printer if the front panel
changes were made and not saved to flash memory. VGL then
restarts as if just powered up (no dynamic forms in form library,
character substitution sets reset, starts printing in upper left
corner, etc.).
NOTE: Any EVFU setting in the Line Printer Plus Emulation (by direct codes
or the VGL (cc)L command) is not reset (see page 89).
plot